I have a 220V small vacumm pump and would like to rewire to 110V?
December 30th, 2009 | by admin |This pump is used for vacuum bagging composites ie, carbon fiber, fiberglass with epoxy resins. The process is called "vacuum bagging" . Have a this brand new vac pump and would like to rewire it to 110V.
you may be able to rewire it IF it has a multi-tapped input.
If not, just have an electrican add a 220v outlet for you. US Homes are serviced with 220v, where it is split at the breaker panel. Your stove, hot tub, pool heater, some water heaters, are 220v
2 Responses to “I have a 220V small vacumm pump and would like to rewire to 110V?”
By Keith on Dec 30, 2009 | Reply
It may or may not be possible.
You will need to research the motor to see it it supports various supply voltages and wire hook ups.
It may make more sense to use a transformer and step up your available 110 volts to the needed 220.
References :
By ►BobB◄ on Dec 30, 2009 | Reply
you may be able to rewire it IF it has a multi-tapped input.
If not, just have an electrican add a 220v outlet for you. US Homes are serviced with 220v, where it is split at the breaker panel. Your stove, hot tub, pool heater, some water heaters, are 220v
References :